Crestron Connected Receiver

[Gary]

So I did my first Crestron connected receiver and I'm pretty impressed.

All of the issues I had revolved around getting everything setup. The setup instructions walk you through getting the receiver into installer setup mode. To do this there is a combination of buttons you press while the receiver is off. The instructions lead you to believe that this will bring up the installer menu, it does not. It turns the receiver on and when you press the setup button on the remote the Crestron setup option is in the menu. On the next power cycle the setup menu goes back to normal. This took me more time than I care to admit to figure out out, so hopefully this saves you guys some time.

Setting the unit up is just like any other Crestron network device, the unit gets an IP ID and you enter the IP address of the processor. For some reason I couldn't get the receiver to communicate with the processor until I gave it (the receiver) a fixed IP address even though it showed online. YMMV

From a programing stand point it's just like the SWAMP or C2N-AMP-4x100.

Attachment 4808

The only real problem I had was that there is no listing of what analogs switch which sources, five minutes in debugger and all was well.

Attachment 4809

In addition I used the zone 2 out to feed the media player to a PAD8 as a music source.



This has all been in and working without any complaints for about 2 weeks.

-----Update---- the setup instructions can be found here, http://support.crestron.com/app/answ...id/5467/kw/avr